UDC-IC, 10Mhz Clock Converter

10mhz clock sine wave converter product photograph

UDC-IC

10 Mhz Clock Converter

Features / Benefits

Description

* Interface - 50 Ohm BNC

* Input - Single 10 Mhz Sine Wave

* Output - Four Ports, 10 Mhz Square Wave

* One In, Four Out Converter / Splitter

* Low Signal Level Detector Circuit

* 110/220VAC or DC Voltage Supply Option

* CE Approved, RoHS Compliant

* Sturdy Aluminum Enclosure
The UDC-IC 10 MHz Clock Converter is intended to accept a standard 10 MHz sinusoidal reference signal, convert it to a typical 5V TTL-level output, and distribute this output to 4 separate devices over individual coax cables.

Each cable driver element is designed to launch a signal through a 50-ohm series termination. With a single high-impedance load at the end of the 50-ohm cable, the load will see the incident signal as a square wave. Reflections back to the source are absorbed for the most part by the series termination in combination with the low-impedance driver.

If the 10Mhz Input Sine Wave is within tolerance, the front panel CLK and DCD LED Indicators will be green. If the 10Mhz Input signal is out of tolerance the CLK and DCD LED indicators will not be illuminated.

The 10MHz receiver card is also equipped with a low signal level detector circuit that cuts off the converter to prevent compromised clock signals from reaching downstream equipment. This will normally happen when the input signal falls below the minimum +5 dBm level. The front panel indicator, DCD will be on when an input signal of sufficient level is seen, and off when the cut-off circuit senses a low level or absent input.

The UDC-IC 10Mhz Clock Converter is simple to use by connecting a 50-ohm Coax Cable to the 10Mhz Sine Wave INPUT marked PORT B located on the rear panel. Then connect from one to four 50-ohm Coax Cables to the OUTPUT ports 1-4 located in PORT A.

The front panel LED marked PWR, CLK and DCD should be illuminated. If the CLK and the DCD LED’s are not illuminated, the UDC-IC 10Mhz Clock Converter is not receiving a good 10Mhz Sine wave.

The UDC-IC has a three year warranty and a 24 hour turnaround on warranty repairs.
   
 

SPECIFICATIONS

Application Interconnection of 10 Mhz systems sine wave to square wave clock distribution
Capacity One Input, Four Outputs
Rear Panel Data Interface One: 10Mhz Sine Wave Input Four: 10Mhz Square Wave Outputs
Data Format Data Transparent at all Data Rates
Data Rates 10Mhz
Front Panel Indicators POWER and each data channel has DCD and CLK
Surge Protection Main power supply
Power Source AC Mains: 100-120 to 200-220VAC @10%, 50/60Hz, 0.16/0.08A, external 110/220 volt select switch, IEC
Power Inlet, (2) 5mm Fuses
DC Mains: DC Voltage, Input Range of -36 to -72vdc
Current Draw at 48vdc: 75ma @ 3.6watts
Environmental Operating Temperature....32º to 122º F (0º to 50º C)
Relative Humidity.............5 to 95%
Non-Condensing
Altitude............................0 to 10,000 feet
Dimensions Height ....... 1.75 inches (4.44 cm)
Width ........ 9.00 inches (20.86 cm)
Length ...... 9.00 inches (20.86 cm)
Weight 3 pounds (1.364Kg)
Warranty Three Years, Return To Factory
Regulatory Approvals UL 60950-1:2003, CAN/CSA-C22.2 No. 60950- 1:2003, FCC Part 15, EN55022:2006, ICES-003, Class A
Ordering Information

Main Unit Part Number: 190000 Model: UDC-IC Description: UDC-IC Interface Converter, 110/220VAC

Part Number: 129105 Model: TTL-4 I/M Description: 4-PORT TTL 50-ohm Driver Interface Module

Part Number: 129109 Model: 10Mhz I/M Description: 10Mhz Receiver/Buffer Interface Module

 

 
Optional 1U Rack Mount Chassis Part Number: 204000 Model: UDC-IC Rackmount Description: Rackmount UDC-IC Main Unit, 110/220VAC
Included with each unit: 1) Operations Manual
2) Grounded Power Cord
Optional Accessories 1) Spare Data Center Fuses
A) 160ma Fuse, Qty (2) Part # 714000
B) 80ma Fuse, Qty (2) Part # 714001

PRODUCTS

Network Delay Simulators IP Traffic Generators Data Broadcast Units Digital Sharing Devices Interface Converters Modem Emulators Code Operated Switches Serial Network Adapters TDM Multiplexers

 

New Product Short Form & Capabilities Catalog wan latency emulator catalog-download

logo GSA Contract Holder

25th

Anniversary

logo

Contact Us

Site Map | Legal Information
Copyright 2019 East Coast Datacom Inc
All Rights Reserved